Air dryer v2a.pde
I adapted the sample problem 3D_flowbox.pde to make the attached 3D simulation. A gas flows in through an array of holes in a wall at z=-wall, and out through a slot at z=long. The x-axis is the width dimension (x=0 is the center line), the y-axis is the height dimension.
I'm unable to get plots of the vector vz, or vector(vy,vz), on planes of x=constant (i.e., x=0, or aligned with some feature of interest like an inlet hole). Contour plots of vz confirm that variable is defined on these planes of x=constant, but the vector(vz) and vector(vy,vz) plots fail - the vector color scale doesn't change from 0.99 to 1.00 E-300 as the problem runs. The problems are apparent in monitors 9,10,11,12.
Any thoughts? Thanks for your help. (I correctly attached the file in another post below.)
Charlie