Author |
Message |
Bahar Riand (bahar)
New member Username: bahar
Post Number: 1 Registered: 09-2003
| Posted on Saturday, September 06, 2003 - 01:40 pm: | |
Hi All, I'm using the version 3.10 student version. I have a time dependant equations. I put a number of contours. I would like to animate the results once the simulation ends. However, the view button, where the animations option is, is disabled. Is it student version constraint? Best Regards, Bahar |
Robert G. Nelson (rgnelson)
Moderator Username: rgnelson
Post Number: 34 Registered: 06-2003
| Posted on Saturday, September 06, 2003 - 08:49 pm: | |
When FlexPDE runs a problem, all graphics in the PLOTS section are stored to a file named <problem_name>.PG3. After closing the run, you can open the graphics file with the "File | View" menu selection. The "View" commands are active only on a display opened in this mode.
|
Bahar Riand (bahar)
New member Username: bahar
Post Number: 2 Registered: 09-2003
| Posted on Sunday, September 07, 2003 - 01:24 am: | |
Hi Robert, Thanks a lot. Hopefully in the future release i'll be able to open it directly without a need to close the run. |
Robert G. Nelson (rgnelson)
Moderator Username: rgnelson
Post Number: 36 Registered: 06-2003
| Posted on Sunday, September 07, 2003 - 03:50 pm: | |
You don't need to end the FlexPDE session, you just need to close the running input file, to force any buffered plot commands into the .PG3 file.
|