Author |
Message |
Francesca Rossi (francesca)
Member Username: francesca
Post Number: 6 Registered: 12-2003
| Posted on Thursday, April 01, 2004 - 03:14 am: | |
I have a problem with the limited regions: I have 3 layers and I need to model a region only in the second one. I tryed to write as you indicate in the help guide, but the program stil asks to specify the parameters for all layers (I have the same parameters with different values in the three layers). Can you help me? Thank you in advance Francesca Rossi |
Robert G. Nelson (rgnelson)
Moderator Username: rgnelson
Post Number: 133 Registered: 06-2003
| Posted on Friday, April 02, 2004 - 01:18 am: | |
The version 4 consistency check still searches the entire layers x regions array and reports undefined parameters, even in compartments that may be absent in the final mesh. But this should not be a problem if you have given each definition a default value. If you have definitions that are declared without a value, you should add a default, and your problem should go away.
|
Francesca Rossi (francesca)
Member Username: francesca
Post Number: 7 Registered: 12-2003
| Posted on Friday, April 02, 2004 - 03:06 am: | |
Than you very much, it works! Francesca Rossi |