Author |
Message |
Svitlana Subota (photinka)
New member Username: photinka
Post Number: 1 Registered: 02-2007
| Posted on Friday, February 16, 2007 - 11:43 am: | |
I need a different boundary condition on a ring on one of the cube sides. I made a layer for the ring. If I make a 1/4 of a ring it works good. The region is close and I have wanted condition on the hole surface of this region. But if I make hole ring I have necessary boundary condition only on the sides of the ring, not on the hole surface. What should I do?
|
Robert G. Nelson (rgnelson)
Moderator Username: rgnelson
Post Number: 766 Registered: 06-2003
| Posted on Friday, February 16, 2007 - 03:15 pm: | |
I'm not sure I understood what you said, but: 1) boundary conditions stated in a bounding path apply to the sidewalls. 2) boundary conditions stated with a SURFACE qualifier in the regional parameter definition area apply to the selected 3D cut surface. See Help | User_Guide | Using FlexPDE in 3 Dimensional problems | Setting boundary conditions in 3D. |
|